Once the car is lifted, between the catalytic converter & the resonator, you will find 4x M10 bolts, (marked orange in the picture) 2 on each side of the chassis, located in the position shown in the image. Unscrew them
Put the mid-brace such that the holes in the brace align with the holes in the chassis.
Put a drop of threadlocker liquid on each of the 4 bolts.
Install the brace and lightly screw all 4 bolts provided with the brace.
In the X pattern, tighten the bolts to the required Torque of 28Nm.
Done! Enjoy the improved handling
Front Brace:
Apply a drop of threadlocker on each of the 8 provided countersunk m6 allen bolts.
Install the provided brackets onto the bar of the front brace, as shown in image, using the provided countersunk M6 Allen-key bolts, 4 per bracket.
Lift the car and remove the two bolts marked in the image.
Insert the provided bolts into the brace. if additional washers are provided, install them behind the two brackets.
Apply a drop of threadlocker on each of the M12 bolts
Align the slots on fully assembled brace onto two bolt holes on the chassis from which the two bolts were removed(marked orange in previous pic).
Tighten lightly to ensure alignment.
Once the alignment is assured, fully tighten the bolts.
Done! Enjoy reduced wheel-hop, improved front end agility & better stability!
